DIY Screwdriver Storage Rack out of Scrap
Counterbores were drilled using a spade bit, then finishing the hole with the correct size drill for the screwdriver shaft.
I like the fact, I don't have to pull the screwdriver the full length of its shaft to get it out of the holder. I only have to lift it up about a 1/4 to 1/2inch to get it out.
![](https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEi_d1V8DovNtNVC57dlUIAQnnAS1yeZa0DyFbzYPTMntFtdAlaNJ0X7TDpTE2kDsLsqSj8-VlGoXpNoUgu_dk45h9Ii371YMhdO85WU-xeWwdBJe1Q24XU1qlFfbbQts2BhUsljtE6uUqJQ/s320/20131209_200310.png)
Finished Screwdriver Storage Rack
Another Screwdriver rack
Comments
Post a Comment